cmlbay54 发表于 2020-3-13 17:30:15

[Question]using eeprom

Herkese merhaba!
Dgus ekranımın eepromunu kullanmak istiyorum. T5L ekranım var. (Model: DMT80600L104_01WT). Mikrodenetleyicimin (Atmega128A) eepromu program uygulamam için yeterli değil. Dgus'un eepromunu uart ile kullanabilir miyim? Bir komut bulamadım? "komut setv2.4" eeprom ilgilenen kimse. Bu konu hakkında bilen var mı? Pls bana yardımcı olur.

ZJB19921204 发表于 2020-3-13 20:43:41

Hallo?Skærmene kan kun fungere gennem det specificerede instruktionsform.Du kan ikke direkte få adgang til flash på skærmen, men du kan skrive operationelle systemprogrammer på skærmen for at håndtere nogle logiske domme og operationer.

cmlbay54 发表于 2020-3-14 14:26:31

I did not fully understand what you mean :L
There must be a way to use the screen's memory.
Because an electronic card I am using uses the screen's memory.
I'm sure this. Because when I connect a new card to the same screen, it shows the old saved value. However, this value had to be reset when I connected the new card. This means that the old card has recorded this value in the memory of the screen.
But how can it do that?

Kingsly0110208 发表于 2020-3-14 15:24:35

1.You need to format your SD card in the DOS.
2.You need to check the folder named DWIN_SET in the SD card.
3.The LCD is worked at TA model,like "AA ****** CC 33 C3 3C"
页: [1]
查看完整版本: [Question]using eeprom