The image is not good, same problem resolution seems bad, seems at 640 x 480 pixels not 800 x 600 ?? the Hmi was working okay before the wrong flash :( When you downloading images, please select 16 bits 本帖最后由 nimrod 于 2020-4-14 09:27 编辑
Thank you, but tried all of this, its like the m600 firmware M600_V55.BIN is not the good one ??not configured for 800x600 resolution, every image i upload is not shown correctly ??
see image, when i do calibration you see two cross on the left, like two screens overlapped ?If it was rotated by 90degree the cross would be on top right ?no ?
EDIT : i confirmthe screen with M600_V55.BINhas changed to 640x480 resolution ? see the image, you see a full 640x480 image, and another one starting at the bottom
Is there any other m600 firmware available ?please ?
I saw the handshake picture you uploaded before, the display mode configuration is 0X00, which is the corresponding 640 * 480 and 320 * 240 resolution screen of the M600 core, 800 * 600 should correspond to 0X0C or 0X0D, you can modify the display Mode look Hellothank you
The display doesn't change to 0C or 0Dwhen i push "SET"when i do handshake it stay the same screen config mode 0X00
The only thing who change is touchscreen config mode if i let 0X1E control the gui ...
I know the register R0 is for resolution, but it is for k600+ notfor m600 or k600i did not find any documents or command sets for m600 and k600
I do thinkthe firmware is not good ? is thereolder kernel available ??i recal it had kernel v4.3 Managed to partially repair a damaged m600 kernel version 4.3the usb port is damaged and the m600 flexible connector latch was broken
With kernel 4.3 the display revert to 800x600with the config screen Id mode at 0D, i played with modes 00 up to mode 0Dand yes 0Dis the good one
But with kernel 5.5 nothing works, no change, always screen Id mode 00
Now I needotherolder than v5.5m600 kernel ???
页:
1
[2]