[Question]DMG12800l 010_ 01WTC

jupiter

using tool : DGUS Tool V7.618.exe
using system : DMG12800L010_1WTC

1. Use config generator.exe, but the CFG file is not applied.

2. It does not change from the existing DEMO background image.

3. Can you format a flash?

What should I do?

沃特玛贞帥斯基

Hello, sir! I am very pleased to serve you.
1. You can create a CFG configuration file directly with the software, and modify the corresponding parameters in it.
2. The background picture of this screen should be generated in ICL format, and the factory default name is 32.icl.
3. The screen can format SPI NAND Flash, see the attached picture for details, thank you

jupiter

DGUS Tool V7.618.exe

Where can I get the English User Manual (pdf)?

Kingsly0110208

You can refer to the following links：

迪文开发者论坛 - Powered by Discuz! http://inforum.dwin.com.cn:20080 ... &extra=page%3D1

jupiter

It was very helpful to your kindness.

I want to ask you one more question.


If the CFG file is corrected incorrectly, no screen appears. What should I do? Even if I restore the CFG file to its original state, there is no download screen on the blue screen, but it only appears on the black screen.

Kingsly0110208

Can the screen light up normally now？
Confirm whether the screen model is correct？

jupiter

I don't know what I did wrong.

The screen is black when you turn on the power.

Can you fully reset it?

Kingsly0110208

You tell the exact model first. The model is on the back of the screen

jupiter

사용 도구 : DGUS Tool V7.618.exe
시스템 사용 : DMG12800L010_1WTC

Even if you insert a demo program, it's still black SCREEN

AHYEAH

jupiter 发表于 2020-8-7 11:33
사용 도구 : DGUS Tool V7.618.exe
시스템 사용 : DMG12800L010_1WTC

Please make sure the screen connect successfully first.

Then put the required files into the DWIN_SET folder and download them to the screen through SD card. The sequence is: power off – insert SD card - power on - blue screen reading SD card content, download complete display "SD card process END! " ——Power off, exit SD card - power on.

Also need to configuration background picture ICL file save position on 08 position in CFG file.